admin

My Kinetico does not draw brine in brine position

Answer: 1. Check stems missing or not working correctly. Normally yellow on base level, two check stems. Make sure they are fitted correctly. Replace or add check stems. 2. Plugged venturi. Clean out venturi, but do not damage this item. Clean out Level 3 venturi throat and molded venturi nozzle (Do not use anything sharp). 3. Plugged …

My Kinetico does not draw brine in brine positionRead More »

My Kinetico Water Softener will not go into automatic regeneration

Answer: 1. Water meter disc is not turning. 2. Control disc will not automatically advance out of service position. 3. Damaged teeth on control disc. Action: Replace regeneration start pawl and replace control disc. With the head removed manually rotate flow controls and check operation of gears. Scrutinise all cogs and check teeth on all the …

My Kinetico Water Softener will not go into automatic regenerationRead More »

Why does my Kinetico Water Softener keep running to drain

Water running to drain? With softeners and filter/softeners, start by testing the drain water. If the drain water is hard, the tank currently in service has a problem with its drain valve. If the drain water is soft, start with number 1 below. 1. Problem  Reason  Solution The balance piston O-ring is  not seated properly. Water will …

Why does my Kinetico Water Softener keep running to drainRead More »

Use Less Chemicals

You may even find you can use as little as a quarter of the amount you were using before. Hardness minerals in water interfere with soap’s cleaning ability. Once they are removed, soap can do its job better. Even though you’ll use less soap, you’ll get more suds and cleaner results. It’s especially important to …

Use Less ChemicalsRead More »